£115.48

Sadolin PV67 is a two-pack varnish ideal for areas that receive a lot of wear and tear

FREE SHIPPING On All Orders Over £50

QUICK & EASY
PAYMENTS

ONLINE
EXPERT SUPPORT

FREE SHIPPING On All Orders Over £50

QUICK & EASY
PAYMENTS

ONLINE
EXPERT SUPPORT

Availability: 97 In Stock
Sku: A0001117

Sadolin PV67 is a two-pack varnish ideal for areas that receive a lot of wear and tear, severe abrasion or knocks and bangs, such as bar tops or heavy traffic floor areas like dance floors or hallways.


 

Sadolin PV67 is a two-pack varnish ideal for areas that receive a lot of wear and tear, severe abrasion or knocks and bangs, such as bar tops or heavy traffic floor areas like dance floors or hallways.


 

• For floors, bar tops and surfaces subject to high levels of abrasion.

 

• Not suitable for use on laminate.

 

• Available in gloss or satin finish.

 

• Allow 24 hours before moving furniture back into the room

 

BrandSadolins
Pack Size1lt, 5lt
Touch DryWithin 30 miniutes
Recoat Time after 1st coat2 hours
Recoat time after subsequent coats2-4 hours
  
Coverageup to 12sq mtrs per litre
MPN5028741, 5028738, 5028739, 5028742
GTIN7391306088230, 7391306088209, 7391306088216, 7391306088247

How To Apply Sadolin PV67

 

Sadolin PV67 Heavy Duty Varnish should be applied in full flowing coats ensuring all surfaces are fully coated.

 

For best results use a soft bristle brush, lambs wool applicator or quality woven short to medium pile roller.

 

Clean application tools must be used ensuring any fibre shed is removed prior to use by thorough washing (then allow to fully dry) or by using masking tape.

 

Following surface preparation in accordance with the manufacturers recommendations, finish with 3 full coats of Sadolin PV67 Heavy Duty Varnish allowing a minimum of 3-4 hours drying between coats.

 

Avoid over brushing as this will cause brush marks and result in a poor quality finish and also reduce the level of protection afforded.

 

Carefully denib the fist coat using a fine grade nylon abrasive pad or a fine grade (P240 or finer) wet or dry silicone carbide abrasive paper in the direction of the grain before overcoating.

 

Do not break through the surface coating.

 

Remove all dust.

 

All subsequent coatings should be applied as soon as possible after the previous coat has fully cured.

 

If recoating after more than 48 hours it is essential to lightly abrade the surface to remove surface gloss and leave overnight for the surface to condition prior to over lacquering

 

For further technical information on Sadolin PV67 please refer to relevant product datasheet and comprehensive pack instructions.

View FileSadolin PV67 Data Sheet Size: (293.63 KB)

View FileSadolin PV67 H&S Sheet Size: (162.54 KB)

Sadolin PV67 is a two-pack varnish ideal for areas that receive a lot of wear and tear

Just added to your wishlist:
My Wishlist
You've just added this product to the cart:
Go to cart page