© Abington Decorating Supplies Ltd. 2015  All rights reserved

Home Trade Paints Wood Care Performance Coatings Fabrics Designer Paints Lighting Wallcoverings

Contact Us

Click & Collect

MARGARD ANTI-CLIMB PAINT

Reference No.: 39-Line

A non-drying oil based solvent-free coating typically used as a soft, non-drying coating to deter climbing of walls, fences, plyons, etc.

Colours available : Black, other colours available please contact us for information    

Appearance Of Dried Film : Semi-gloss    

Volume Solids : 100%    

Theoretical Coverage : Approximately 8.0m² per litre depending on film build applied    

Drying Time At 20°C :

(will vary with temperature, air movements, etc.) Touch Dry : N/A

Film Dry : N/A

Overcoat : N/A    

Packaging : 5 litre containers    

Shelf Life : 2 years in unopened containers when stored under cover in good storage conditions.    

Storage : Under cover with temperature range of 5°C to 32°C.    

Surface Preparation : Apply to dry, sound surface    

Application : Apply by brush    

Clean-up : Dacrylate Thinner R70  

DACRYLATE MARGARD ANTI-FLY POSTER TEXTURED FINISH

Reference No.: 86-Line

A modified polyurethane with selected non-stick additives to provide a non-stick surface to deter fly-posting. The textured additive gives outstanding ‘release’ properties. Graffiti can also be easily removed.

Fully compliant to Environmental Protection Act (1990) as required by Guidance Note PG 6/23 (97) Clause 20(d).

Colours available : Full range to special order, please contact us for more information.    

Appearance Of Dried Film : Textured finish    

Volume Solids : 57%    

Dry Film Thickness : Typical 50 microns / Range 40-70 microns    

Theoretical Coverage : 11.4m² per litre at 50 microns    

Drying Time At 20°C :

(will vary with temperature, air movements, etc.) Touch Dry : 20 hours

Film Dry : 6 hours

Overcoat : See below    

V.O.C.: 390 gram/litre    

Packaging : 5 litre composite pack    

Shelf Life : 2 years or longer in unopened containers when stored under cover in good storage conditions.    

Storage : Under cover with temperature range of 5°C to 32°C.    

Surface Preparation : Apply over Dacrylate Epidac 2 HB Aluminium Primer Item 115 Ref.: 90-268 (dry film thickness of primer –approximately 75 microns.    

Application Conditions : Humidity : Do not apply at relative humidities above 90%. Substrate temperature must be at least 3°C above dew point.

Temperature : Do not apply at temperatures below 5°C.

Note : Dacrylate Margard Anti-Fly Poster Finish will cure at temperatures down to 0°C, however at temperatures below 15°C, the base and hardener will thicken considerably and affect application characteristics. At low ambient temperatures, a small addition of Dacrylate Thinner R6may be required to ensure optimum application properties.

Effect of Temperaturs on Drying/Overcoating Times

5°C 10°C 20°C 30°C    

Surface Dry 6 hours 4 hours 2 hours 1 hour    

Hard Dry 16 hours 12 hours 8 hours 4 hours    

Overcoating Times Minimum 16 hours 12 hours 8 hours 4 hours    

Maximum *Consult Dacrylate Technical Services Department  

Application : Site Application : Apply by brush or roller. (May be applied by spray in-stop, air-ed spray masks and extraction required.)

Apply at an approximate wet film thickness of 90 microns to achieve DFT of 50 microns.

NB.: Polychromatic colours such as RAL 9006 and RAL 9007 may be susceptible to slight variations in colour depending on application methods and the type of paint. In order to obtain the best colour and appearance, these colours are best spray applied.    

Graffiti Removal : Graffiti, (eg. aerosol sprays and felt-tip pens), can be removed using Dacrylate Marclean GP Remover. (Gel-form or in aerosols.) Surface should be rinsed with water immediately after removal of graffiti. (Please follow instructions on Marclean GP datasheet.)    

Pot Life (at 20°C) : 4 hours    

Mixing Ratio by Volume : 5 parts Base to 1 part Activator (colours)

4 parts Base to 1 part Activator (clear)    

Clean-up : Dacrylate Thinner R6

MATHYS PEGAGRAFF HYDRO ANTI GRAFFITI PAINT

Pegagraff® Hydro is undoubtedly the ideal protection for facades and buildings that are susceptible to graffiti. This waterborne colourless and extremely abrasion resistant varnish is solvent resistant: that is why all kinds of paint can be removed quickly and efficiently by means of Pegagraff® Hydro Cleaner.Colourless anti-graffiti protection for many substrates.

Colourless 2K anti-graffiti protection

Exceptionally abrasion resistant

Very hard finish

Easy to apply and clean

Also useful as a colourless varnish for internal walls

UV-resistant

Water-based formulation, low odour

ANTI GRAFFITI PAINT